Simrad ST90 - Page 132

130
457420/A
•Youknowhowtosetuptheparametersforserialandlocalareanetwork(LAN)
communication.
•Thecommunicationparametersrequiredforthesensorinterfaceareknown.
Context
TheI/OSetuppageprovidestwolists;oneforserialportsandoneforEthernet(LAN)ports.
Eachlistissupportedwithasetoffunctionstosetupandmonitorthecommunicationports.
Selecttheportyouwanttoworkwithandthenselectoneofthebuttonsbelowthelist.
Tip
TheSensorspageintheBITE(Built-InTestEquipment)dialogboxprovidesanoverviewof
allthecommunicationlinesandsensorsinuse.Allrelevantstatusinformationisprovided.
YouopentheBITEdialogboxfromtheSetupmenu.
WhenyouworkintheInstallationdialogbox,youmustalwaysselectApplytosavethe
changesmadeonapage.Y oumustdothisbefore youcontinueworkingonadifferentpage.
Procedure
1OpentheSetupmenu.
2OntheSetupmenu,selectInstallation.
ObservethattheInstallationdialogboxopens.Thisdialogboxcontainsanumberof
pagesselectedfromthemenuontheleftside.
3OntheleftsideoftheInstallationdialogbox,selectI/OSetup.
4ObservethattheavailableserialandnetworkinterfaceportsontheProcessorUnit
arelisted.
5SetuptherelevantserialorEthernet(LAN)communicationparameters.
aSelecttheinterfaceportyouwishtosetup.
bSelectSetupbelowthelisttoopentheSerialPortSetuporLANPortSetupdialog
box.
cSetuptherelevantserialorEthernet(LAN)communicationparameters.
ThecommunicationparametersdenedforNMEA0183are:
•BaudRate:4800b/s
•DataBits:8
•Parity:None
•StopBits:1
SimradST90OperatorManual