166
Still Image Operations
Chapter 7 Frame Memory
• To execute the effect, you must assign the user region to
which FM1 is assigned to a region selection button in the
numeric keypad control block.
For details of assigning to region selection buttons, see
Chapter 19 “Control Panel Setup (Panel)” (Volume 2).
In the Frame Memory menu, effect creation follows the
image file names. Of the eight characters in the file names,
if files have the same characters except for the last three
characters they are treated as an image file group, and the
effect is created with the last three (numeric) characters in
sequence.
When creating the effect in pair mode (see page 157), the
files used must be main files and sub files with the same
last three (numeric) characters in the file name.
To recall a continuous sequence of still images, create an
effect in the user region with the still image files as a
keyframe, and run the created effect.
With the 720P format or 1080P format, you can
continuously recall images using the frame memory in
units of two frames only.
Creating an effect with still image files as a
keyframe
1
In the Frame Memory menu, select VF1 ‘Still’ and
HF5 ‘Create Key Frame.’
The Create Key Frame menu appears.
• A thumbnail appears for each group of files having
the same characters, except for the last three
characters, in the file name.
• When [Pair] is on, only pair files (each pair
comprising a main file and a sub file) appear.
• When [Pair] is off, both single files and pair files all
appear.
2
In the frame memory selection area, select the frame
memory to be assigned (see page 161).
3
Select the desired folder in the folder selection area.
By pressing [More] to switch the display, you can
select from a maximum of 12 folders.
Thumbnails of the files within the selected folder
appear.
4
Turn the knob to select the register number in the user
region.
To search for an empty register in the user region, use
the numeric keypad control block.
For details, see step 3 of “Recalling a Register” in
Chapter 13 (Volume 2).
5
Use the arrow keys or turn the knobs to scroll the
thumbnail display of the files.
6
Select the thumbnail of the files to be used for the
keyframe.
7
If necessary, turn the knob to check the animation
effect in the thumbnail display.
8
Using the region selection buttons in the numeric
keypad control block, select one of the regions (User1
to User8) to which the frame memory output signals
have been assigned.
9
Carry out either of the following.
• To clear the effect register selected in step 4, and
create a new effect: press [Create Key Frame].
• To add to the end of the effect register selected in
step 4, press [Append Key Frame].
A confirmation message for creating the effect
appears.
If there is an inappropriate condition for creating the
effect, an error message appears.
For details of error messages, see “Error Messages”
in the Appendix (Volume 2).
10
Press [OK].
This creates the effect in the selected user region
register.
To cancel creating the effect
Press [Cancel].
Notes
Notes
Knob Parameter Adjustment Setting values
5 Register Effect
register
number
1 to 99
Notes
Knob Parameter Adjustment Setting values
1 Scroll Thumbnail
display
scrolling
1 and upwards
Knob Parameter Adjustment Setting values
3ViewerAnimate
thumbnail
display of
files
00:00:00 and
upwards
To Next Page
Loading...
