Sony MVS-7000X - Setting the Key Priority by a Menu Operation

72
Key Priority Setting
Chapter 3 Signal Selection and Transitions
To change the priority of more than one key, repeat
this operation as required.
Changing the key priority for after the
transition
When executing a transition, turning on the next transition
selection button [KEY PRIOR] causes the keys to be
rearranged based on the set priority.
To set the key priority for after the transition, use the
following procedure.
1 In the transition control block, hold down the [PRIOR
SET] button and press the [KEY PRIOR] button to
turn it on. Do not release the [PRIOR SET] button
before advancing to step 2.
The [KEY PRIOR] button lights green, and it becomes
possible to change the key priority setting for after the
transition.
2 Hold down the [PRIOR SET] button, and press the one
of the next transition selection buttons [KEY1] to
[KEY4] ([DSK1] to [DSK4] buttons in the PGM/PST
bank) for the key you want to bring to the front after
the transition.
To set the priority to be the same as before the
transition, press the [BKGD] button.
• The [BKGD] button is only effective when in the
mode for changing the key priority for after the
transition.
• To select [Key5] to [Key8], or [DSK5] to [DSK8]
requires an assignment (see page 345).
• The key priority establishes a separate priority order
within each of the groups of keys 1 to 4 and keys 5
to 8. You can make any setting within the groups of
keys 1 to 4 or keys 5 to 8, but not for combinations
of keys from different groups. For example, it is not
possible to set a priority sequence of keys 1, 5, and 2.
When the next transition selection button [KEY
PRIOR] is on, the selected key appears on top on the
preview monitor. The priority of keys other than the
selected one does not change.
3 To change the priority of more than one key, repeat the
previous operation as required.
4 Execute the transition.
The keys are rearranged based on the set priority.
Setting the Key Priority by a Menu
Operation
When using keys 1 to 8, set the priority separately for the
two groups (see page 73).
Changing the priority of the currently
inserted keys
1 In the M/E or PGM/PST menu, select first VF7 ‘Misc,’
then HF3 ‘Key Priority.’
The Key Priority menu appears.
2 For each of <Priority1>, <Priority2>, <Priority3>, and
<Priority4>, select a key, to determine the key priority
sequence.
The keys are inserted in the key priority sequence with
priority 1 at the front.
Notes
Key 1 selected.
Key priority: 1, 3, 4, 2
Key priority: 3, 1, 4, 2