401
Path Setting
Chapter 13 Keyframe Effects
You can also use the [TRIM] button to enter a
difference value (see page 392).
4
Press the [ENTER] button to confirm the entry.
Path Setting
The term “path” (see page 383) refers to the specification
of how interpolation is carried out from one keyframe to
the next.
Set keyframe paths in the Key Frame >Path menu.
To access the Key Frame >Path menu
In the menu control block, press the top menu selection
button [KEY FRAME], then select HF3 ‘Path.’
Basic Procedure for Path Settings
Selecting the category
From the 16 buttons in the function button area, select the
category for which you want to make the setting.
First row: path settings for the switcher M/E1 and PGM/
PST banks
Second and third rows: path settings for User1 to User8
Fourth row: path settings for DME local channel and
global channel 3D transforms and effects
Making switcher path settings
This section describes settings for M/E-1 Key1 as an
example.
The area for the VF buttons shows the names of items.
A B sign by a button indicates that pressing it opens a more
detailed setting menu.
The status area shows the settings for Xpt, Hue, and Curve.
However, depending on the item, these parameters may or
may not be present.
Whenever you set a path or modify its setting, be sure to
press the [MOD] button in the keyframe control block. The
setting does not become effective unless the [MOD] button
is pressed.
Notes
To Next Page
Loading...
