427
Shotbox Register Editing
Chapter 15 Utility/Shotbox
Shotbox Register Editing
You can carry out the following editing on shotbox
registers.
• Lock: Write-protect the contents of the register.
• Copy: Copy data from one register to another.
• Move: Move data from one register to another.
• Swap: Swap the contents of two registers.
• Delete: Delete the contents of a register.
• Name: Attach a name to a register.
The procedures for shotbox register editing are similar to
the procedures described in “Effect Register Editing”
(page 408).
Unlike in effect register editing, however, it is not
necessary to specify a region in shotbox register editing.
To Next Page
Loading...
