404
Saving Effects
Chapter 13 Keyframe Effects
2
Press the [RUN] button.
This executes the effect as far as the next keyframe.
When the [REV] button is lit, it is executed as far as
the previous keyframe.
Repeating an effect
1
Press the [EFF LOOP] button, turning it on.
2
Press the [RUN] button.
This executes the effect repeatedly, from the first
keyframe to the last keyframe.
When the [REV] button is lit, the effect is executed in
the reverse direction.
3
To stop the repeating effect, press the [EFF LOOP]
button, turning it off, or press the [REWIND] button.
Saving Effects
When you recall an effect, the currently recalled effect is
automatically saved in a register. This is referred to as the
auto save function.
You can disable the auto save function in a Setup menu.
By means of the following operation, you can also specify
a register and save an effect in it.
Saving an effect in a specified register
Specify the register using the numeric keypad control
block.
1
Press the [EFF] button, turning it on.
This assigns the numeric keypad control block to
keyframe operations.
2
Press the region selection button corresponding to the
region for which you want to save the register, turning
it on .
3
Press the [STORE] button, turning it on.
4
With the numeric keypad, enter the number of the
register in which you want to save the effect.
To find an empty register, instead of entering a
number, press the [.] (period) button. To search for an
empty register common to all currently selectable
regions, press the [.] button again.
To search for an empty register in the 100 range, press
[1], [0], [0], [.] (period) in this order. Similarly, to
search for an empty register in the 200 range, press [2],
[0], [0], [.] (period), and to search for an empty register
in the 300 range, press [3], [0], [0], [.] (period).
The register number appears in the display. If the
number is followed by a letter ‘e’ or ‘E,’ this indicates
the following.
e: The selected register is empty for the regions
selected in step 2.
E: The selected register is empty for all selectable
regions.
5
To add an attribute (effect dissolve) (see page 381),
press the [+/–/EFF DISS] button, turning it on.
6
Press the [ENTER] button.
This saves the current effect in the specified register,
and turns off the [STORE] button. The [RCALL]
button and [STORE STATS] button both light.
To undo the saving of an effect
Hold down the [STORE STATS] button and press the
[UNDO] button.
To Next Page
Loading...
