390
Recalling a Register
Chapter 13 Keyframe Effects
[ALL]: This selects all valid regions.
[MASTR]: This selects the master timeline (see page
405)
The regions that can be selected simultaneously are
those assigned to the region selection buttons in the
numeric keypad control block (see page 491).
It is not possible to select [MASTR] and other regions
simultaneously. If selected simultaneously, the master
timeline takes precedence.
The first button pressed lights green as the reference
region, and any subsequently pressed buttons light
amber.
Pressing one of the amber-lit buttons, while holding
down [EFF], turns the button green to indicate its
corresponding region as the new reference region.
For details of the precedence order for becoming the
reference region, see “Reference region” (page 379).
The display shows the name of the reference region,
and the number of the last register recalled for this
region.
3
Enter the number of the register you want to recall,
using the numeric keypad.
To find an empty register, instead of entering a
number, press the [.] (period) button. To search for an
empty register common to all currently selectable
regions, press the [.] button again.
To search for an empty register in the 100 range, press
[1], [0], [0], [.] (period) in this order. Similarly, to
search for an empty register in the 200 range, press [2],
[0], [0], [.] (period), and to search for an empty register
in the 300 range, press [3], [0], [0], [.] (period).
The register number appears in the display. If the
number is followed by a letter ‘e’ or ‘E,’ this indicates
the following.
e: The selected register is empty for the regions
selected in step 2.
E: The selected register is empty for all currently
selectable regions.
4
To apply a temporary attribute (effect dissolve), press
the [+/–/EFF DISS] button.
It is not possible to apply temporary attributes to the
master timeline.
5
Press the [ENTER] button.
This recalls the specified register.
When the master timeline is recalled, the region
selection buttons light according to the saved region
information.
To undo the recall of a register
Immediately after recalling the register, press the [UNDO]
button to undo the operation.
After recalling the master timeline, you cannot undo the
recall.
Notes
Notes
Notes
To Next Page
Loading...
