409
Register Operations in the Menus
Chapter 13 Keyframe Effects
2
Press the region display in the upper part of the list to
display a selection window, then select the region in
the selection window. Selecting multiple regions is
also possible.
To select all regions, press [ALL].
Operation between regions
Operation between regions is possible in the following
cases.
• M/E-1 and P/P regions
• Two of the User1 to 8 regions of the same
configuration
• Two of the DME ch1 to 8 (including Global) regions
3
Press [OK].
The selected region name appears in the upper part of
the list.
4
Using any of the following methods, select the desired
registers.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
• To select all registers, press [ALL].
5
To copy without transferring the name, in the <Copy>
group, press [W/o Name], turning it on.
6
In the <Copy> group, press [Copy].
This carries out the copy.
If, for example, the copy destination register is write-
protected or the same register is specified both as the
copy source and destination registers, a confirmation
message appears. Press [OK] to cancel the copy.
Merging effect registers
1
In the Effect menu, select VF2 ‘Effect 1-99’ and HF3
‘Copy/Merge.’
• The Copy/Merge menu appears.
• The left side of the status area shows a list for the
register coming afterward when merged. The right
side shows a list for the register coming before when
merged.
2
Press the region display in the upper part of the list,
and in the selection window select the region.
Selecting multiple regions is also possible.
To select all regions, press [ALL].
3
Press [OK].
The selected region name appears in the upper part of
the list.
4
Using any of the following methods, select the
register.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
5
Press [Merge].
Deleting data from effect registers
1
In the Effect menu, press VF2 ‘Effect 1-99’ and HF6
‘Delete.’
The Delete menu appears.
2
Press the region display in the upper part of the list to
display a selection window, then select the region in
the selection window. Selecting multiple regions is
also possible.
To select all regions, press [ALL].
3
Press [OK].
The selected region name appears in the upper part of
the list.
4
Using any of the following methods, select the desired
registers.
• Press directly on the list in the status area.
• Press the arrow keys to scroll the reverse video
cursor.
• Turn the knobs.
Knob Parameter Adjustment Setting values
1 From Reg Copy source
register number
1 to 99
2 To Reg Copy destination
register number
1 to 99
3 Num Select number of
registers
1 to 99
Knob Parameter Adjustment Setting values
1 From Reg The register
coming
afterwards when
merged
1 to 99
2 To Reg The register
coming before
when merged
1 to 99
Knob Parameter Adjustment Setting values
1 Register Register number 1 to 99
3 Num Select number of
registers
1 to 99
To Next Page
Loading...
