Sony MVS-7000X - Page 537

537
Settings Relating to Video Switching (Transition Menu)
Chapter 20 Switcher Setup (Switcher)
On: When the [FTB] button is pressed, a fade-to-black is
carried out.
Off: Even when the [FTB] button is pressed, no fade-to-
black is carried out.
The PGM2 to PGM4 settings are only valid in Multi
Program mode or DSK mode.
Setting a preset color mix
1 In the Switcher >Transition menu, press [Preset Color
Mix].
The Preset Color Mix menu appears.
The status area shows the stroke mode setting for each
M/E bank, the setting for whether or not the key status
is maintained, and the one-time mode setting.
2 In the <Stroke Mode> group, select whether to carry
out a transition in one stroke or two strokes.
Normal: Carry out a preset color mix with two
transition operations.
Single: Carry out a preset color mix with a single
transition operation.
In bus fixed mode (see page 536), the setting is fixed
to “Single.”
3 In the <Non Drop Key> group, select the key setting
for a transition including a key.
To carry out the transition with the key state
maintained, press [Key1] to [Key8], turning them on.
4 If each time a transition ends the transition type is to
return to the previous setting, press [One Time
Enable].
Settings relating to fader lever operations
To select the way in which the fader lever position and the
transition progress are related, use the following
procedure.
1 In the Switcher >Transition menu, press [Transition
Curve].
The Transition Curve menu appears.
2 In the <Fader Curve> group, select the fader lever
operation mode.
Normal: The transition progress is linear, according to
the fader lever position. (Factory default setting)
Adv Tally Mode: When the fader lever is moved from
the end of its travel, the tally is output slightly
before the transition starts.
Notes
Notes