xiv Sun Blade 150 Service Manual • June 2002
FIGURE 7-2 Removing the Diskette Drive 7–3
FIGURE 7-3 Removing and Replacing the Smart Card Reader 7–5
FIGURE 7-4 Removing and Replacing a Primary Hard Drive 7–7
FIGURE 7-5 Installing a Secondary Hard Drive 7–10
FIGURE 7-6 Secondary Hard Drive Cabling Configuration 7–11
FIGURE 7-7 Removing and Replacing a CD-ROM or DVD-ROM Drive 7–12
FIGURE 8-1 Removing and Replacing the CPU 8–3
FIGURE 8-2 JP3 OpenBoot PROM Jumper Settings for 650 MHz and 550 MHz CPUs 8–4
FIGURE 8-3 Removing and Replacing the NVRAM/TOD 8–6
FIGURE 8-4 DIMM Installation Order 8–8
FIGURE 8-5 Removing and Replacing a DIMM 8–9
FIGURE 8-6 Removing and Replacing a PCI Card 8–11
FIGURE 8-7 Removing and Replacing the Motherboard 8–14
FIGURE 8-8 JP1/JP2 Jumper Settings for the Flash PROM 8–15
FIGURE 8-9 Removing and Replacing the Riser Board 8–17
FIGURE 9-1 Replacing the System Cover 9–2
FIGURE 9-2 System Power Switch 9–2
FIGURE A-1 Minimum Clearance for System Cooling A–4
FIGURE A-2 IDE Cabling Configuration A–5
FIGURE A-3 External and Internal Serial Ports A–7
FIGURE B-1 Power Supply Connector J501 Pin Configuration B–2
FIGURE B-2 Secondary Power Supply Connector J505 Pin Configuration B–3
FIGURE B-3 USB Connector J17, J18 Pin Configuration B–4
FIGURE B-4 IEEE 1394 Connector J20, J30 Pin Configuration B–5
FIGURE B-5 TPE Connector J19 Pin Configuration B–6
FIGURE B-6 Serial Port Connector J36 Pin Configuration B–8
FIGURE B-7 Riser Board Serial Port Pinouts (J13) B–9
FIGURE B-8 Accessing the Second Serial Port Through a PCI Card Slot B–10
FIGURE B-9 Serial and Video Port Connector Extensions B–11
FIGURE B-10 Parallel Port Connector J9 Pin Configuration B–12
To Next Page
