SWF Dual Function E Series User Manual



Dual Function 1
××
1 Embroidery Machine's motion test
 Jump Test
Select Jump Test in [Fig.5.13.3-1]. Press JUMP TEST button. The jump solenoid on each head will run for
around 0.5 seconds.
 Wiper Test
Select Wiper Test in [Fig.5.13.3-1]. Press WIPER TEST button. The wiper motor on the heads switched on will
run for around 0.5 seconds.
 Picker Test
Select Picker Test in [Fig.5.13.3-1]. Press PICKER TEST button. The picker solenoid installed around the hook
will run for around 0.5 seconds.
 Trimmer Test
Select Trimmer Test in [Fig.5.13.3-1]. Press TRIM TEST button. The trimmer solenoid installed on the trimmer
cam will run for around 0.5 seconds.
 Holding Test
Select Holding Test in [Fig.5.13.3-1]. Press HOLDING TEST button. The holding solenoids of the main shaft
installed on the upper shaft will run for around 0.5 seconds.
 Upper Thread Sensor Test
Select Thread Sensing Test in [Fig.5.13.3-1]. Press THREAD SENSING TEST button. The thread detecting
sensors on the thread tension adjustment plates on the heads switched on will run. The heads that touch the thread
detecting plate and the thread detecting spring will blink, while the heads that do not touch the plate and the
spring will not blink.

Motion test of Dual Function E Series and Dual DM Series
 Jump Test
Press the jump test button in <Fig. 5.13.3-1> and press the start button. Then, the jump motor attached to each
head begins operating. If other motion testing button is pressed, the concerned test will be conducted after the
jump test is finished.
 Wiper Test
Press the wiper test button in <Fig. 5.13.3-1> and press the start button. Then, it operates the wiper motor once.
 Picker Test
Press the picker test button in <Fig. 5.13.3-1> and press the start button. Then, the picker solenoid attached
around the hook begins operating for some 0.5 seconds.

SWF Dual Function E Series Specifications

General

Brand	SWF
Model	Dual Function E Series
Category	Sewing Machine
Language	English