embroidery is not properly conducted. In this case, operate the needle bar with problem only by beginning
embroidery a little bit before the problem area, and then the unwanted sewing previous made with the lower
thread can be corrected through overlapped embroidery. This function enables the setting of the relative start
position of all needle bars start compared with the machine stop position within the range of 1 to 20 stitches. The
default value is 3[stitches].
Frame Forward / Back Moving Unit
It sets the number of stitches moved by one bar switch when you move the frame forward or backward with a bar
switch.
- Basic setting is 1 stitch and you can set it in the range of 1-10 stitches in the unit of 1 stitch.
Optimize Method
Gauge refers to making running stitches in parts off the design exclude by certain length. It sets the distance from
the exclude to the gauge.
- Basic setting is 10mm and you can set it in the range of 1~30mm.
S/W Limit Setting
It sets whether to use the virtual frame limit function.
- Basic setting is NO.
Thread Break Moving
The frame automatically moves to the back of the machine when the machine stops after detecting a thread break
for convenient threading of the upper thread. You can set the length of the frame movement.
- Basic setting is 0mm and you can set it in the range of 0~50mm in the unit of 1mm.
To Next Page
Loading...
Need help?
General
