64 097-55501-01 Issue 6 – June 2003
1
TimeHub 5500 System Guide
2.3.2 Shelf–to–Connection Panel Cabling
Figure 2-2 shows an example of shelf–to–wire-wrap panel connections with
two wire-wrap panels (090-41902-01) with built-in wire-wrap pins.
At the rear of the shelf, each three-connector ribbon cable is connected from
one connector on the output connector card to two of the connectors labeled
“TO” or “OUTPUT” on the rear of the connector panel. The outputs are
marked on each cable: one of the cables is marked “1–10”; the other cable is
marked “11–20”.
Figure 2-3 shows an example of the shelf-to-wire-wrap panel for the
expansion shelf.
To Next Page
Loading...
Need help?
General
