1
097-55501-01 Issue 6 – June 2003 85
2
5
3
Installation
3.7.3 Output Module Blank Panels (Master and
Remote Shelf Only)
The blank panel (p/n 093-55599-01) can be used in the master and remote
shelves only.
Install blank panels for output modules in the spaces where no output
modules are installed.
3.7.4 Output Module Blank Panels (Expansion Shelf
Only)
There are two types of output module blank panels for the expansion shelf.
• The blank panel p/n 093-55599-02 is a single height blank panel.
It can be used to cover only one output module space.
• The blank panel p/n 093-55599-03 is a double height blank panel.
It is used to cover a complete output group, covering both output
module spaces of a group.
Order and install the desired output module blank panels in the back of the
expansion shelf.
3.8 Cabling
3.8.1 Shelf–to–Connection Panel
Connect the factory-supplied three-connector ribbon cable from the
connector on the output connector card on the rear of the shelf to two of the
connectors labeled “TO” or “OUTPUT” on the rear of the connection panel.
The outputs are marked on each cable (one of the cables is marked “1–10”;
the other cable is marked “11–20”). Repeat as needed, depending on the
number of outputs used. Refer to Figure 3-9.
To Next Page
Loading...
Need help?
General
