Technogym Run MED - Disassembling the Elevation Motor

RUN MED: Service & Maintenance Manual - rev. 1.0
7.16. DISASSEMBLING THE ELEVATION MOTOR
Figure 7.16-1
Carry out the procedure described in paragraph
7.11. “Disassembling the electrical box”.
1. Remove the split pins a and then the pin b
securing the elevation motor assembly to the
machine frame.
Figure 7.16-2
d then the pin d.
4. Remove the elevation motor.
To reassemble the elevation motor, carry out the
above steps in reverse order.
2. Turn the machine over on one side.
3. Remove the split pins c an
Page 7.21