RUN MED: Service & Maintenance Manual - rev. 1.0
9.1.12. ENABLE UP/DOWN MOTOR
This parameter enables or disables use of the machine incline. To change the selection, when the
LED matrix shows the current setting:
UP-DOWN: xxx
Press the +/- GOAL keys to select the desired option out of those listed in the table below:
UP-DOWN
ENABLED <default>
DISABLED
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or previous
parameter.
9.1.13. ENABLE MULTI-LANGUAGE MODE
The machine can be configured to allow selection of the language at each session. To change the
selection, when the LED matrix shows the current setting:
LANGUAGE : xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
LANGUAGE
FIXED <default>
OPTIONAL
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
9.1.14. RESETTING PARAMETERS TO DEFAULT VALUES
It is possible to reset the user menu parameters to their default values. To select the function, when
the LED matrix shows:
DEFAULT CONFIG.
Press ENTER to confirm the operation, use the + or – speed keys to move to the next or preceding
parameter. If the ENTER key is pressed the LED matrix will show:
CONFIRM ?
press ENTER to confirm, or cancel by pressing the CLEAR key for a few seconds.
Page 9.5
To Next Page
Loading...
