RUN MED: Service & Maintenance Manual - rev. 1.0
9.1.5. PAUSE TIME
It is possible to set a maximum duration of the pause for every exercise in seconds, with values
ranging from 10 to 999. To change the setting, when the LED matrix shows the current maximum
pause time:
PAUSE TIME : xxx
Press the ENTER key to change the parameter: the current value of the parameter will start to
blink, at this point press the CLEAR key to erase the current value and then use the number keys to
enter the desired new value.
Press ENTER to confirm the changes made, and use the + or – speed keys to move to the next or
preceding parameter.
The default value of this parameter is 60.
9.1.6. ENABLE TGS
It is possible to enable or disable the use of the TGS reader. To change the selection, when the LED
matrix shows the current setting:
TGS: xxx
Press the +/- GOAL keys to select the desired option from those listed in the table below:
TGS
ENABLED <default>
DISABLED
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
9.1.7. ENABLE KEYBOARD
It is possible to disable the keyboard so that the machine can only be used with the TGS. To change
the setting, when the LED matrix shows the current one:
KEYS: xxx
Press the +/- GOAL keys to select the desired option out of those listed in the table below:
KEYS
ENABLED <default>
DISABLED
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
Page 9.3
To Next Page
Loading...
