Technogym Run MED - Weekly Maintenance Operations; Checking the Emergency Stop; Complete Operation

RUN MED: Service & Maintenance Manual - rev. 1.0
Page 10.2
10.2. WEEKLY MAINTENANCE OPERATIONS
These operations can be carried out by the machine owner and do not require any
special skills.
The weekly machine maintenance operations consists of simple cleaning, lubrication and checking
the emergency stop to ensure the correct and safe functioning of the machine.
10.2.2. COMPLETE OPERATION
For the weekly maintenance operations, proceed as follows:
10.2.1. CHECKING THE “EMERGENCY STOP”
1. With the machine turned on and moving at a speed of approximately 5 km/h (3 mph), trip the
emergency stop and check that the machine halts, displaying the “PRESS A KEY” message.
1. When the machine is switched on, check that it performs the power-on self test procedure
which:
• sounds the buzzer;
• resets the incline.
At the end of which the machine goes into standby, awaiting a keyboard command.
2. To check the correct operation of the machine:
• get on the machine;
• press the “Start” key to begin the exercise and check that the tread belt motor starts;
• press the “+” and “-” keys on the keyboard and check that the tread belt speed varies
accordingly;
• press the “↑“ and “↓“ keys and check that the incline varies accordingly;
• put on the heart rate meter and check that the machine correctly reads the heart rate value;
• grasp the sensors and check that the machine correctly reads the heart rate value.