Technogym Run MED - Read from Low Kit; Write to Low Kit; Default Setting

RUN MED: Service & Maintenance Manual - rev. 1.0
Page 9.12
UPDOWN SETTINGS
+20%:
-5.0%:
WRITE TO
LOW KIT ?
DEFAULT
SETTINGS ?
READ FROM
LOW KIT ?
.......................
addition to the 50 configuration also includes the 3 sub-functions
t
from the low kit memory to view them on the display, scroll using the
READ FROM LOW KIT ?
ENTER to read the paramete return to the upper menu level by
w he +/- keys
un il t
WRITE TO LOW KIT ?
he low kit, and return to the upper menu level by pressing
LEAR for a few seconds.
.2.3.3. Default setting
roll using the +/- keys until the LED display
hows:
DEFAULT SETTING ?
press ENTER to load the default parameter values, and return to the upper menu level by pressing
CLEAR for a few seconds.
In
d
parameters, this function
escribed below:
9.2.3.1. Read from low ki
To read the parameter values
+/- keys until the LED display shows
press
p
rs from the low kit, then
ressing CLEAR for a few seconds.
9.2.3.2. Write to low kit
To rite the values of the currently displayed parameters to the low kit, scroll using t
t he LED display shows:
press ENTER to write the parameters to t
C
9
To load the default parameter values to the display, sc
s
To write these parameters to the low kit, use the “Write to low kit” function.