Technogym Run MED - Distance; Priority Setting; Maximum Exercise Time

RUN MED: Service & Maintenance Manual - rev. 1.0
Page 9.2
9.1.2. DISTANCE
It is possible to choose between EUROPEAN units (kg and km) or IMPERIAL units (pounds and
miles). To change the selection, when the LED matrix shows the current setting:
DISTANCE : xxx
Press the +/- GOAL keys to select the desired unit of measurement from the options listed in the
table below:
DISTANCE
KM <default>
MLS
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
9.1.3. PRIORITY SETTING
If signals are available from both the chest band and hand sensors, this parameter determines which
is the preferential source for displaying the heart rate value. Obviously, if only one of these two
signals is available, it will be used even if not configured as the preferential heart rate source. To
change the selection, when the LED matrix shows the current setting:
PRIORITY : xxx
Press the +/- GOAL keys to select the preferential source from those listed in the table below:
PRIORITY
BAND <default>
HANDS
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
9.1.4. MAXIMUM EXERCISE TIME
It is possible to set a maximum duration for the exercise in minutes, with values ranging from 1 to
9999. To change the setting, when the LED matrix shows the current maximum time limit:
MAX TIME: xxx
Press the ENTER key to modify the parameter: when the current value of the parameter starts to
blink, press the CLEAR key to erase the current value and then use the number keys to enter the
desired value.
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
The default value of this parameter is 9999.