Technogym Run MED - Start-Up Check Procedure

RUN MED: Service & Maintenance Manual - rev. 1.0
Page 11.2
11.2. START-UP CHECK
Following installation and after every technical intervention on the machine, plug it into a power
outlet, set the power switch to ON.
To check the correct operation of the machine:
• press the emergency button and check that the tread belt stops;
During power-up the machine resets the incline. After completing the power-on reset, the machine
goes into standby, awaiting a keyboard command.
• get on the machine;
• press the “Quick Start” key to begin exercising and check that the tread belt motor starts;
• press the “+” and “-” keys on the keyboard and check that the tread belt speed varies
accordingly;
• press the “↑” and “↓” keys and check that the incline varies accordingly;
• put on the heart rate meter and check that the machine correctly reads the heart rate value;
• grasp the sensors and check that the machine correctly reads the heart rate value;