RUN MED: Service & Maintenance Manual - rev. 1.0
11.3. CHECKING THE ASSEMBLY OF THE TREAD-BELT
COMPONENTS
Check that the following have been correctly assembled: tread belt, running deck and rollers. In
particular, make sure that:
11.4. CHECKING THE ASSEMBLY OF THE FOOTREST
PLATFORMS
Check the correct assembly of the machine guards, making sure they are all in place and correctly
secured as described in chapter 7 of this manual, so that no part of the machine is left exposed that
may cause injury to the user.
• The tread belt has been properly assembled, and its tension correctly adjusted as described in
chapters 7 and 8 of this manual.
• The running deck is in good condition and has been correctly assembled as described in chapter
7 of this manual.
• The front and rear rollers have been correctly assembled as described in chapter 7 of this
manual, and do not produce any unusual noise during operation.
Check that the footrest platforms of the machine have been correctly assembled, making sure that:
• The two footrest platforms have been correctly assembled as described in chapter 7 of this
manual.
11.5. CHECKING THE ASSEMBLY OF THE GUARDS
Page 11.3
To Next Page
Loading...
