RUN MED: Service & Maintenance Manual - rev. 1.0
Page 9.16
Erro r
code
Error
number
Description
Oli 10
Inverter overload caused by a DC current exceeding, for the maximum
allowed time (I
2
t), the maximum permissible threshold for the inverter.
OLm 11
Motor overload caused by a DC current exceeding, for the maximum
allowed time otor in
question.
(I
2
t), the maximum permissible threshold for the m
OLr 12 Braking resistor overload.
Ot 13
Over-torque due to an even momentary overload of the inverter. Is
generated when the torque output of the motor exceeds a pre-established
limit for a pre-established time.
OCH 16 HW overcurrent.
MST 17
hich occurs, operating in closed loop mode with the
encoder active, if the inverter fails to reach the target speed even after
attempting to reduce the reference frequency.
Motor lockout w
EM 19
signa
Emergency. Is generated when the AT drive receives a software
emergency signal that is not accompanied by a hardware emergency
l.
SHC 23
Short Circuit. Is generated in the event of a short circuit between a motor
phase and earth.
Use the + speed key to advance to the se the message with the details of the
urrent error will continue to reappear.
.2.6. STANDARD SETTINGS
This function simultaneously resets the User menu, low kit, UpDown table parameters to their
default values and the operating data of the machine. To access this menu, when the LED display
shows:
STANDARD SETTING
press ENTER, the following message appears:
CONFIRM ?
TER again to reset all parameters to their default values, or return to the upper menu level
y pressing CLEAR for a few seconds.
next error, otherwi
c
9
Press EN
b
This function does not alter the language and the TV standard setting.
9.2.7. LOW KIT MENU
ware of the inverter. To access this menu, when the LED
structured as follows:
This function directly accesses the firm
display shows:
LOW KIT MENU
ress ENTER. This function isp
To Next Page
Loading...
