Technogym Run MED - Reset Errors; Com.fault X

RUN MED: Service & Maintenance Manual - rev. 1.0
ress ENTER to read the errors from the low kit, and return to the upper menu level by pressing
shows:
RESET ERRORS ?
history log, and return to the upper menu level by pressing CLEAR
his is a counter that display the number of errors in serial communication between the upper and
roll using the
/- keys until the display shows:
COM.FAULT X
To reset it press E TER
press TER to et a .
9.2.5.4. View E ors
For error g erate r history log records the information in the table
belo
• Counter;
• Error Code;
• d-mm – hh
• Voltage when the error occurred;
• C t * 10 n th
• Speed km/h when th
The correspondence between error codes and descriptions is given in the table below:
p
CLEAR for a few seconds.
9.2.5.2. Reset errors
To clear the error history log in both the low and high kit, scroll using the +/- keys until the LED
display
press ENTER to clear the error
for a few seconds.
9.2.5.3. COM.Fault
T
the lower kit. This counter increase each time a communication fault is detected. Sc
+
N , the LED display shows:
RESET COM.FAULT?
EN res nd return to the upper menu level by pressing CLEAR for a few seconds
rr
every en d by the machine, the erro
w:
date (d -yy :mm);
urren whe e error occurred;
e error occurred.
Error
code
Error
number
Description
OH 1 nd of the PFC. Overheating of the heat sinks of the AT drive a
OC 2 Overcurrent, even if only transient, on the inverter output.
UU 3 Undervoltage condition, due to an even transient drop in line voltage.
OU 4 age. Overvolt
PE 6
EEPROM error. Is generated when there is an error detected in the data
stored on the EEprom.
EdC1 7 Elevation motor encoder error.
EdA 8 AC motor encoder error.
OtM 9 AC motor thermal cutout open.
Page 9.15