RUN MED: Service & Maintenance Manual - rev. 1.0
Page 9.4
9.1.8. MODIFIABLE TARGET HEART RATE
It is possible to enable or disable modification of the target heart rate during a constant heart rate
exercise. To change the selection, when the LED matrix shows the current value:
HR: xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
HR
MODIFIABLE <default>
NOT MODIFIABLE
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
9.1.9. ENABLE CUSTOM MESSAGES
It is possible to configure whether a custom message is displayed when the machine is in the
standby state. To change the selection, when the LED matrix shows the current setting:
CUSTOM MESS. : xxx
Press the +/- GOAL number keys to select the desired option out of those listed in the table below:
CUSTOM MESS.
YES <default>
NO
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
9.1.10. EDIT MESSAGES
It is possible to modify the custom messages; press ENTER to invoke a submenu which displays
the first custom message, then use the +/- speed keys to move to the other messages. Press the
ENTER key again to begin editing a message, or hold down the CLEAR key for a few seconds to
return to the upper menu level. While editing a message, move the cursor using +/- GOAL, select
the desired letter using the +/- speed keys and use CLEAR to enter a blank space character. Press
ENTER to save the modified message, or hold down the CLEAR key to cancel and return to the
upper menu level.
9.1.11. CHANGE MESSAGE LANGUAGE
It is also possible to display the custom standby messages in the language selected with the
preceding parameter. To extend the language setting to the predefined custom standby messages,
when the LED display is showing the current selection:
CHANGE MESS.LANG.
Press ENTER to confirm the selection, use the + or – speed keys to move to the next or preceding
parameter.
To Next Page
Loading...
