RUN MED: Service & Maintenance Manual - rev. 1.0
Page 9.14
press EN the parameters to
CLEAR for a few seconds.
9.2.4.3. usage data
he machine usage data on the display is updated every 10 minutes. This means that, whenever the
TER to write the low kit, and return to the upper menu level by pressing
Machine
T
machine is switched off, any changes after the last memory update will be lost.
MESSAGE ON DISPLAY DESCRIPTION
Life AC M: Minutes x 10 of tread belt motor operation
Life DC M: Minutes of elevation motor operation
L Minutes x 10 of operation of the upper assemblyife Kit H:
Life Kit L: Minutes x 10 of operation of the lower assembly
Tot. Km: Total km travelled
By selecting one of the items in the abov ible to modify its content, but only after
aving cleared its value. When the ENTER key is pressed the message “Reset life...” appears,
NTER again resets the value of the selected
em, while pressing CLEAR reverts to the old value.
.2.5. ERRORS LOG
ress ENTER. This function is structured as follows:
e table it is poss
h
followed by the name of the selected item; pressing E
it
9
This function accesses the machine’s error history log. To access this menu, when the LED display
shows:
ERRORS LOG
p
Error 10
Error 1
RESET ERRORS ?
READ FROM
LOW KIT ?
ERRORS LOG
.......................
To read the error history log from the low ew it on the display, scroll using the +/-
eys until the LE y shows:
READ FROM LOW KIT ?
In addition to the error history log, this function also includes the 2 sub-functions described below:
.2.5.1. Read from low kit 9
kit memory to vi
k D displa
To Next Page
Loading...
