Technogym Run MED - Default Parameters

RUN MED: Service & Maintenance Manual - rev. 1.0
9.5. DEFAULT PARAMETERS
It is possible to restore all the parameters to the default factory values.
Carry out the operation by setting parameter C-2 (address 802) to “1”, following the detailed
instructions provided in paragraph 9.2.7.2 “Config. registers”.
Although the changes made to the parameters come into effect immediately, they are not
automatically stored in permanent memory; this requires a specific write operation
effected using the command C-0.
Save the data by setting parameter C-0 (address 800) to “0”, following the detailed instructions
provided in paragraph 9.2.7.2 “Config. registers”.
Page 9.23