Technogym Run MED - High Kit Version; BOOT Version; Key Reader Version

RUN MED: Service & Maintenance Manual - rev. 1.0
MENU –P–
Par. Address Description Value Par. Address Description Value
P-120 421 Manual boost [%] 30 P-382 468 Autoreset delay 50
P-121 422 Boost factor src 0 P-383 469 Autores flt rly 1
P-122 423 Auto boost en 1 P-400 470 Ext fault mode 0
P-140 424 Magn curr gain 30 P-420 471 Volt reduc mode 0
P-160 425 Osc damping gain 10 P-421 472 V reduction fact 100
P-180 426 SW clamp enable 1 P-422 473 V fact mult src 0
P-200 427 Ramp CurLim mode 474 Frequency thr 1 0 0 P-440
P-201 428 Curr lim in ramp 475 Freq prog 1 hyst 5 170 P-441
P-202 429 En lim in steady 0 P-442 476 Frequency thr 2 0
P-203 430 Curr lim steady
-
P-443 477 Freq prog 2 hyst 5
P-204 431 Curr ctrl P-gain
-
P-460 478 Const speed tol 5
P-205 432 Curr ctrl I-gain
-
P-461 479 Const speed dl 1
P-206 433 Curr ctr feedfwd
-
P-480 480 Heatsnk temp lev 70
P-220 434 En DC link ctrl
-
P-481 481 Heatsnk temp hys 5
P-221 435 DC-lnk ctr Pgain
-
P-500 482 Switching freq 9
P-222 436 DC-lnk ctr Igain
-
P-501 483 Sw freq reduc en 0
P-223 437 DC-link ctr FF
-
P-520 484 Overmod max lev 0
P-240 438 OverTorque mode
-
P-540 485 Out Vlt auto adj 0
P-241 439 OT curr lim thr
-
P-560 486 Deadtime cmp lev 9
P-242 440 OT level fac src
-
P-561 487 Deadtime cmp slp 50
P-243 441 OT signal delay
-
P-580 488 Startup display 1
P-260 444 Motor OL prot en
-
P-600 489 Speed dsply fact 100
P-280 445 Brake res OL en
-
P-999 490 Param prot code 0
9.2.8. HIGH KIT VERSION
This function displays the SW version of the display. To do this, when the LED display shows:
HIGH KIT VERSION
press ENTER, the message that identifies the SW version, will appear.
9.2.9. BOOT VERSION
This function displays the BOOT version. To do this, when the display shows:
BOOT VERSION
press ENTER to display the message which identifies the BOOT version.
9.2.10. KEY READER VERSION
This function displays the SW version of the TGS reader. To do this, when the LED display shows:
KEY READER VERS.
press ENTER, the message that identifies the SW version, will appear.
Page 9.21