RUN MED: Service & Maintenance Manual - rev. 1.0
10.4.5. CHECKING THE WEAR OF THE DRIVING ROLLER
1. With the rear and driving rollers, running deck and tread belt disassembled, check the state of
wear of the driving roller. Replace if there are evident signs of wear.
10.4.9. CHECKING AND CENTERING THE TREAD BELT
2. With the machine moving at a speed of approximately 10 km/h, check the centering of the tread
belt. If any anomalies are found, call in an authorized Technogym service technician or make
the adjustment.
2. With the machine in motion, check the noisiness of the bearings. Replace in the event of
excessive noise.
10.4.6. CHECKING THE WEAR OF THE REAR ROLLER
1. With the front and rear rollers, running deck and tread belt disassembled, check the state of
wear of the rear roller. Replace if there are evident signs of wear.
2. With the machine in motion, check the noisiness of the bearings. Replace in the event of
excessive noise.
10.4.7. CHECKING THE SHOCK ABSORBERS
1. With the front and rear rollers, running deck and tread belt disassembled, check the condition of
the shock absorbers on either side of the running deck. Replace if they are cracked or show
signs of breakage.
10.4.8. CHECKING THE TREAD BELT MOTOR DRIVE-BELT
1. Turn off the machine by placing the switch in position 0 (OFF).
2. Unplug the mains lead from the wall outlet.
3. Open the motor guard.
4. Check the state of wear of the tread belt motor drive-belt, turning it by hand using the motor
flywheel. Replace if there are evident signs of wear.
1. With the machine stopped, check the tension over the entire surface of the tread belt, turning it
by hand. If any anomalies are found, call in an authorized Technogym service technician.
10.4.10. CHECKING THE DISPLAY
1. Check the operation of all the keys on the keyboard.
2. Check the operation of all the LEDs and the buzzer.
Page 10.5
To Next Page
Loading...
