RUN MED: Service & Maintenance Manual - rev. 1.0
Figure 7.7-4
3.
tie. Make sure they are
secured but not too fasten.
5. Mark the sponge in order to remember the
position of the coil.
Fold the sponge on the cardio receiver as
shown in the picture.
4. Secure the sponges on the receiver with some
tape or with a cable
Figure 7.7-5
6. Encase the cardio receiver in a plastic bag.
7. Close and secure the plastic bag with some
tape on the cable as close as possible to the
cardio receiver, as indicated in the figure.
Figure 7.7-6
8. Let out from the handlebar hole just the
required cable to position the receiver into
the plastic housing.
the receiving coil must be oriented
upwards and toward the user (as shown
in the figure to side).
Page 7.9
To Next Page
Loading...
