Terumo CAPIOX EBS Circuit with X coating - Page 69

Operation Procedure
 Using the Fast Clamp Arm
1. Confirm that the knobs (two places) of the Fast Clamp Arm
are secured. (Figure 1-25)
If the knobs are not secured, the Fast clamp holder may move and it may
cause the Fast Clamp fall when you attach the Fast Clamp.
Figure 1-25
2. Attach the Fast Clamp Arm to the IV pole of the
Cart (Figure 1-26
a ), and secure it with the knob.
(Figure 1-26
b )
• The Fast Clamp Arm is secured.
Figure 1-26
3. Attach the Fast Clamp to the Fast Clamp Arm
(Figure 1-27
a ), and secure it with the knob.
(Figure 1-27
b )
• The Fast Clamp is secured.
Figure 1-27
4. Insert the plug of the Fast Clamp into the fast clamp
connector on the rear panel. (Figure 1-28)
Align the plug of the Fast Clamp with the slot of the fast clamp connector, and
insert the plug until you hear a click.
Do not forcefully insert the plug.
Figure 1-28
40
Check
Check
Knob
Fast clamp holder
Fast Clamp Arm
Knob
IV pole
Knob
Fast
Clamp
Knob
Fast clamp connector
Plug