Texas Instruments TI-86 - Displaying and Editing a List Element; Deleting Elements from a List; Removing a List from the List Editor

158
Chapter 11: Lists
11LISTS.DOC TI-86, Chap 11, US English Bob Fedorisko Revised: 02/13/01 2:30 PM Printed: 02/13/01 3:03 PM Page 158 of 1611LISTS.DOC TI-86, Chap 11, US English Bob Fedorisko Revised: 02/13/01 2:30 PM Printed: 02/13/01 3:03 PM Page 158 of 1611LISTS.DOC TI-86, Chap 11, US English Bob Fedorisko Revised: 02/13/01 2:30 PM Printed: 02/13/01 3:03 PM Page 158 of 16
Displaying and Editing a List Element

Move the cursor onto the fifth element of
ABC123
. In the entry line, the list name,
the element number in parentheses, and
the element’s full value are displayed.
# # # # #

Switch to edit-element context and edit the
element in the entry line.
5
M D
6
- ~ E
F
4

Enter the edited element. Any expression
is evaluated and the value is stored to the
current element.
b (or # or $)
Deleting Elements from a List
To delete a single element from a list, move the cursor onto the element and press
3
. The
element is deleted. You can clear all elements from a list in any of three ways.
♦
In the list editor, press
$
to move the cursor onto a list name and press
: b
.
♦
In the list editor, move the cursor onto each element, and then press
3
one by one.
♦
On the home screen or in the program editor, enter
0¶dimL
listName
to set the
dimension of
listName
to
0
(A to Z Reference).
Removing a List from the List Editor
To remove a list from the list editor, move the cursor onto the list name and then press
3
.
The list is not deleted from memory; it is only removed from the list editor.
To cancel any editing and
restore the original element
at the cursor, press
:
b
.
You can enter an expression
as an element.