Peripheral Installation
Auto Attendant
6-54
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
◆ Program 15: Selects Automatic Release (AR) on Voice Mail, AA or voice calls. This
will provide automatic release (if the calling party disconnects) without waiting for the
safeguard timer in Program 10-3.
Built-in Auto Attendant Installation
The built-in Auto Attendant feature only requires the installation of a feature key and
customer-supplied announcement devices to deliver announcements to callers. The feature
does not require the installation of any other devices.
➤
To install the customer-supplied digital announcement devices
Note
In Figure 6-28 and elsewhere in this manual, announcement devices are referred to
as A1 and A2. A1 designates a primary announcement device, and A2 a secondary
announcement device. The prime marks following the designation distinguishes the
multiple announcers from each other.
1. Ensure that the PCB that will connect with the device is installed per:
Chapter 2 – DK40 Installation for the KSTU3.
...or Chapter 3 – DK40 Universal Slot PCBs for the RSTU or PSTU.
2. Connect the devices to the selected circuit per wiring diagrams:
◆ Chapter 2 – DK40 Installation for the KSTU3.
◆ Chapter 3 – DK40 Universal Slot PCBs for the RSTU and PSTU.
◆ Chapter 4 – DK40 Universal Slot PCB Wiring.
3. Ensure that the feature key is correctly installed per:
◆ Chapter 2 – DK40 Installation for KKYS/RKYS installation on K5RCU3
4. Program the system per the instructions in “Built-in Auto Attendant Programming” on
Page 6-52.
5. Record the message and dialling prompts on the announcement device per the device
manufacturer's instructions.
To Next Page
Loading...
