Configuring Protocol VLAN Configuration Example
Configuration Guide
189
3) Choose the menu L2 FEATURES > VLAN > 802.1Q VLAN > Port Config to load the
following page. Set the PVID of port 1/0/2 and port 1/0/3 as 10 and 20 respectively .
Click Apply.
Figure 3-6 Port Configuration
4) Choose the menu L2 FEATURES > VLAN > Protocol VLAN > Protocol Template and
click
to load the following page. Enter IPv6 in the protocol name, select the
Ethernet II frame type, enter 86DD in the Ether Type field, and click Create to create
the IPv6 protocol template.
Tips:
The IPv4 protocol template is already provided by the switch. You only need to
create the IPv6 protocol template.
Figure 3-7 Create the IPv6 Protocol Template
5) Choose the menu L2 FEATURES > VLAN > Protocol VLAN > Protocol VLAN Group
and click
to load the following page. Select the IP protocol name (that is the
IPv4 protocol template), enter VLAN ID 10, select port 1, and click Create. Select the
IPv6 protocol name, enter VLAN ID 20, select port 1, and click Create.
To Next Page
Loading...
