8 Stakeout Workflow
The software creates a Stake Marker report. A graphical diagram shows how to put an elevation
mark on the stake. Depending on the settings for catch point marking in the Trimble icon
menu, you will get guidance to one or two more stakes which mark the point. Single Stake,
Dual Stake, and Batter Rail methods are available. The placement and marking of these stakes
is completely guided. The software remembers which tab of the stakeout report was last
viewed and opens the same tab after staking the next point.
7.
Instead of staking a certain station it is also possible to stake a line at random stations using
these buttons on the bottom right in the status bar:
Tap… to…
stake at fixed intervals starting at a certain station
stake at random intervals somewhere along the line
Trimble SCS900 Site Controller Software User Guide 81
To Next Page
Loading...
Need help?
General
