17
2020/09
3 For Your Safety
The product is designed according to state-of-the-art technology. However, residual risks still exist.
Observe the following warnings and safety notices to prevent damage to persons and property.
Turck accepts no liability for damage caused by failure to observe these warning and safety notices.
3.1 Intended Use
The devices are only intended for use in industrial applications.
The BL20 I/O modules are part of the BL20 system. They provide the I/O-functions and can only be
used in combination with a BL20 gateway, the interface to the higher level controllers.
The devices may only be used as described in this manual. Any other usage shall be considered
improper and Turck shall not be held liable for any resulting damage.
3.2 General Safety Instructions
The device may only be assembled, installed, operated and maintained by professionally trained
personnel.
The device may only be used in accordance with applicable national and international regula-
tions, standards and laws.
The device only meets the EMC requirements for industrial areas and is not suitable for use in res-
idential areas.
To Next Page
Loading...
