Mounting and Wiring
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
472
Procedure:
† Insert the colored connection markers, according to the module wiring (see wiring diagrams in
the module chapters), into the slots provided immediately below each connection level on the
base module.
The table shows the meaning of the colors and connection types.
14.1.5 Jumpers for relay modules
Please observe:
To multiply signals and/or save wiring, it can be useful to cross-connect a number of base mod-
ules for relays. To achieve this, jumpers (QVR) are available as accessories in various sizes.
Procedure:
† Press the jumper as far as it will go into the slots provided on the front (facing down) of two
adjoining base modules.
Color of markers Connection type
Black Signal cable
red VDC (+24V; +5V)
blue - 0 V
Red-blue System supply
Yellow-green Protective earth conductor
Green Shield
Brown Phase L1
Fig. 308: Plugging jumpers
To Next Page
Loading...
