477
2020/09
14.1.9 Mounting the electronics modules
Please observe:
The correct base module must have been previously mounted onto the mounting rail.
Electronics modules are fitted onto the previously mounted and wired base modules.
Method:
† Press the electronics module squarely onto the base module, until you hear it lock into place at
the front and back.
Fig. 313: Plugging the electronic modules
NOTE
Before plugging the electronics modules, it is advisable to blow-clean the station with
compressed air. This prevents dust and grains of dirt from contaminating the contacts,
which can negatively influence the communication on the station.
To Next Page
Loading...
