Mounting and Wiring
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
476
14.1.8 Wiring with screw connections
Method:
† Place the screwdriver in the rectangular opening of a connection level on the base module. Turn
the screw ant-clockwise as far as possible, without fully removing it.
† Insert the wire in to the round opening, located directly below the rectangular opening, until it
comes up against a stop.
† Turn the screw clockwise until the wire is fully secured, and cannot be pulled out.
Fig. 312: Screw connection
To Next Page
Loading...
