turck BL20 Series - 9.10.4 Process data mapping; 9.10.5 Diagnostic and status messages

Digital Output Modules
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
260
9.10.4 Process data mapping
m = Offset of output data; depending on extension of station and the corresponding fieldbus.
9.10.5 Diagnostic and status messages
LED status displays
Fig. 206: Wiring diagram BL20-S4x-SBCS
Data Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Output m - - - - - - DO2 DO1
NOTE
With PROFIBUS, PROFINET and CANopen, the I/O data of this module is localized within
the process data of the whole station via the hardware configuration tool of the fieldbus
master.
For DeviceNet, EtherNet/IP and Modbus TCP a detailed mapping table can be created with
the TURCK BL20 DTM in PACTware.
Process data Value Meaning
DOx 0 Digital output inactive
1 Digital output active
LED Display Meaning Remedy
DIA Red Module bus communi-
cation failure
Check if more than two ad-joining electronics mod-
ules have been pulled.
Check the supply of the module bus.
Off No error messages or
diagnostics
–
11 Green Status channel 1 = 1
Off Status channel 1 = 0
21 Green Status channel 2 = 1
SS
23
22
21
13
12
11
––
2414
PE
+
PE
+