turck BL20 Series - 17.7 Cross reference list parameters

523
2020/09
17.7 Cross reference list parameters
NOTE
Due to a product actualization, the parameter texts of the Turck I/O-products have been
revised.
The actual configuration files (GSD-, GSDML-, EDS-files) with the new parameters can be
found under www.turck.com.
Please use the following cross reference list if you work with old configuration files with
old parameter texts (release date before April 2014).
Parameters OLD Parameters NEW
Digital modules
Activate output
0 = no
1 = yes
Invert digital input
0 = no
1 = yes
Wire break diagnostics Activate wire break diagnostics
0 = deactivate
1 = activate
0 = no
1 = yes
Wire break monitoring Activate wire break monitoring
0 = deactivate
1 = activate
0 = no
1 = yes
Input on diagnostic
0 = output substitute value
1 = keep last value
0 = substitute value
1 = current value
Activate input filter
0 = no
1 = yes
Substitute value
0 = off
1 = 1
Short-circuit diagnosis Activate overcurrent diagnostics
0 = deactivate
1 = activate
0 = no
1 = yes
Short-circuit monitoring Activate overcurrent monitoring
0 = deactivate
1 = activate
0 = no
1 = yes
Output on overcurrent Manual output reset after overcurrent