473
2020/09
14.1.6 Mounting end brackets and end plates
End bracket
Please observe:
BL20 stations must be fixed securely onto the mounting rail using two end brackets (BL20-WEW-
35/2-SW). The first end bracket is mounted to the left of the gateway, the second is mounted
together with the end plate at the end of the station.
Method:
† The first end bracket is mounted to the left of the gateway onto the mounting rail
. Clip the end
bracket onto the mounting rail until you hear an audible click ?. If necessary, loosen the screw
beforehand.
† Slide the end bracket up to the gateway
‚‚ and tighten the screw ƒ:
Fig. 309: Mounting end brackets
‚
ƒ
To Next Page
Loading...
