Mounting and Wiring
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
474
End plate
Procedure:
† Insert the end bracket into the recess provided in the end plate ?.
† The end bracket and end plate should be held so that the connectors on the end plate are facing
the last module of the BL20 station.
† Press the end plate onto the mounting rail until you hear an audible click ‚ (if necessary, loosen
the screw beforehand). Then slide the end bracket and end plate up to the last module of the BL20
station ‚.
† Press the end plate with the end bracket firmly up to the last module of the BL20 station. The end
plate’s connectors must lock firmly into the locating holes provided in the module „.
† To secure the end bracket, insert a screwdriver into the hole provided in the end plate and
tighten the screw ….
Fig. 310: Mounting of end plate and end bracket
‚
ƒ
„
…
To Next Page
Loading...
