Mounting and Wiring
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
482
14.2.2 Dismounting the base modules
Please observe:
Base modules can only be dismounted from the right.
The end plate must already be dismounted.
The electronics module must be pulled.
Method for dismounting base modules in slice design:
† Disconnect the wiring from the base module.
† Insert a screwdriver into the rectangular opening in the mounting slot of the base module
.
† Press the screwdriver into the opening
‚; thereby disengaging the connection between the
base module to be dismounted and the adjoining module to its left. Pull the module away to the
right until the rear locating hook disengages. Remove the screwdriver
WARNING
Dangerous electrical voltage
Acute danger to life due to electric shock!
† Switch off all connected voltage supplies!
NOTE
If you are dismounting a base module for a relay, then any mounted jumpers must be
removed from the front of the module before commencing with dismounting.
Fig. 318: Dismounting base modules in slice design
ƒ
‚
To Next Page
Loading...
