481
2020/09
Please observe:
Tools are not usually required to dismount electronics modules.
Method:
† Squeeze both locating hooks towards one another; these are located at either end of the elec-
tronics modules and pull the module away from the base module‚.
Dismounting end brackets and end plates
Procedure:
† Insert the screwdriver into the hole in the end plate and loosen the screw in the end bracket
.
† Slide the end plate and end bracket to the right, away from the last base module. If necessary,
use a screwdriver; CAUTION However take care not to break the end plate connectors which are
locked into the locating holes of the base module
‚
† Loosen the screw in the end bracket to remove the end bracket and end plate from the mount-
ing rail
ƒ.
Fig. 317: Dismounting the end plate
ƒ
‚
To Next Page
Loading...
