Mounting and Wiring
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
484
† There are two locking mechanisms in the middle of the block base module. These must be
unlocked in two steps. Insert the screwdriver into the slot provided in the left-hand locking mech-
anism?
and lever the handle of the screwdriver downwards thereby moving the locking mech-
anism up until it disengages from the mounting rail.
† Insert the screwdriver into the slot of the provided in the right-hand locking mechanism
‚ and
lever the handle of the screwdriver downwards thereby moving the second mounting foot up
until it disengages from the mounting rail. Remove the base module from the mounting rail.
14.2.3 Dismounting the gateway
Please observe:
All base modules on the mounting rail must be either moved away sufficiently to the right or dis-
mounted.
Method:
† Disconnect the connection between the fieldbus and the gateway.
† Insert a screwdriver into the opening provided in the locking mechanism
– on the top of the
gateway – ?, then carefully pull the screwdriver downwards as far as it will go ‚. The spring loaded
locking mechanism is levered upwards and disengages.
† Tilt the top end of the gateway with the screwdriver towards you and away from the mounting
rail
ƒ.
Fig. 321: Dismounting gateway
VORSICHT
Electric voltage (24 V)
Danger of injury due to electric shock!
† Switch off all connected voltage supplies!
ATTENTION
Field bus node missing
Field bus communication disturbed
† Separate the station from the field bus.
ƒ
‚
To Next Page
Loading...
