483
2020/09
† Pull the modules apart at the rear by hand (the module to be dismounted and the adjoining
module)
ƒ. This ”drawing apart” motion automatically disengages the locating hook which con-
nects both modules at the front.
† When both locating hooks are disengaged, slide the base module to be dismounted to the right
„.
† Insert the screwdriver into the slot provided in the locking mechanism … and lever the base
module up and towards you, thereby releasing it from the mounting rail
†.
Method for dismounting base modules in block design:
† Disconnect the wiring from the base module.
† Carry out the steps indicated in Fig. 318: Dismounting base modules in slice design (Seite
482) and Fig. 319: Dismounting base modules from the mounting rail (Seite 483). The
method is identical at this point for both slice and block base modules.
Fig. 319: Dismounting base modules from the mounting rail
Fig. 320: Removing a base module in block design from the mounting rail
„
…
†
‚
To Next Page
Loading...
