367
2020/09
STS_LOAD Status of load function
Set, if the load function is running.
STS_DN Status direction down.
The direction is determined by a signal at the physical input B. The ”signal evaluation
parameter (A, B)” must be set to ”pulse and direction”.
STS_UP Status direction up.
The direction is determined by a signal at the physical input B. The ”signal evaluation
parameter (A, B)” must be set to ”pulse and direction”.
STS_DO1 The DO1 status bit indicates the status of digital output DO1.
STS_DI The DI status bit indicates the status of digital input DI.
STS_GATE 1: Measuring operation running.
STS_UFLW 1: The lower measuring limit was undershot. The bit must be reset with RES_STS: 0 1
zurückgesetzt werden.
STS_OFLW 1: The upper measuring limit was exceeded.
The bit must be reset with RES_STS: 0 1 zurückgesetzt werden.
STS_CMP1 1: Measuring terminated
The measured value is updated with every elapsed time interval. The end of a measure-
ment (expiry of the time interval) is indicated with the status bit STS_CMP1.
The bit must be reset vie the process output with RES_STS: 0 1.
Bit Description
To Next Page
Loading...
