Technology Modules
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
418
Extended status/con-
trol mode
0 = no
1 = yes
If the Extended status/control mode is activated, the
diagnostic messages are mapped into byte 6 of the
process input data (independent of parameter ”deacti-
vate diagnostics”).
Byte 6 of the process output data contains two bits
which may be set to flush the transmit- or the receive-
buffer.
Byte 7 contains the status or control byte. User data are
represented in Bytes 0 - 5.
Deactivate all diagnos-
tics
0 = no
1 = yes
Sending of diagnostics activated/deactivated:
This affects the separate fieldbus-specific diagnostic
message – not the diagnosis embedded in the process
input data.
Stop bits 0 = 1 Number of stop bits.
1 + 2
Parity 00 = none
01 = odd The parity bit is set so that the total number of bits (data
bits plus parity bit) set to 1 is odd.
10 = even The parity bit is set so that the total number of bits (data
bits plus parity bit) set to 1 is even.
Data bits 0 = 7 The number of data bits is 7.
1 + 8 The number of data bits is 8.
Data flow control 00 = none The data flow control is
switched off.
01 = XON/XOFF Software handshake (XON/
XOFF) is switched on.
XON character
(RS422)
0 - 255
(17)
XON character
This character is used to start the transmission of data
from the data terminal device if the software hand-
shake is active.
XOFF character
(RS422)
0 - 255
(19)
XOFF character
This character is used to stop the transmission of data
from the data terminal device if the software handshake
is active.
Parameter name Value Meaning
To Next Page
Loading...
