turck BL20 Series - Page 533

531
2020/09
Technology modules
– BL20-1CNT-24VDC
Diagnostic DO1
0 = 1
1 = off
Digital input DI
0 = normal
1 = inverted
Substitute value DO
0 = 0
1 = 1
Function DI (count mode)
00 = input
01 = HW gate
10 = Latch-Retrigger when edge pos.
11 = Synchronization when edge pos.
Function DI (measurement mode)
0 = input
1 = HW gate
Function DO (count mode)
00 = output
01 = on when cnt value >= ref. value
10 = on when cnt value <= ref. value
11 = pulse when cnt value = ref. value
Function DO (measurement mode)
00 = output
01 = outside of limit
10 = below lower limit
11 = above upper limit
Sensor pulse per revolution
1…65535
Main count direction
00 = none
01 = up
10 = down
Hysteresis
0…255 (Unsigned8)
Pulse duration DO1, DO2 [n*2ms]
0…255 (Unsigned8)
Parameters OLD Parameters NEW